Supports each converter module media configured and monitored ability:
Supports LFP(LLCF and LLR) function
Supports port state enabled/disabled
Supports auto-negotiation/forced mode
Supports port speed and duplex mode Supports wire speed packet forwarding ability as below:
10Base-T : 14880 pps
100Base-TX: 148800 pps Supports module per port basic counters for traffic raw data monitor of fiber and TP port as below:
Rx Packet Counter
Rx Byte Counter
Tx Packet Counter
Tx Byte Counter
Error Counter
Collision Counter
Tx Speed (bps)
Rx Speed (bps) Supports RMON counters for port traffic quality monitoring function Supports bandwidth rating per port ingress and egress rate limit 100Mbps with 1Mbps granularity Supports max packet length: 1916 bytes Supports 802.3x flow control for full-duplex ports and backpressure for half-duplex ports Supports comprehensive types of fiber with different distances and connections, including SC/ST/Bi-Di/LC and so on Supports one 10/100Base-T Fast Ethernet UTP port and one 100Base-FX Fast Ethernet Fiber port Supports Q-in-Q double tagged frame transparent Supports firmware upgrade by TFTP Supports converter mode (only block Pause frame 01-80-c2-00-00-01 and supported L2 protocol) Supports Module Information (S/N, MAC, Model Name) Supports per port basic LEDs for monitoring Supports media type, connector, wavelength and distance information Supports hot-swap and auto reload configuration ability Supports IEEE 802.1p Priority Supports IEEE 802.1q Tag VLAN Supports QOS Classification based on TOS Supports intelligent diagnostic for self detection Supports external loop back capability Supports web-based and text-based management user interface Supports SMTP Supports DHCP client Supports E-mail client (SMTP RFC 821) and Mobile Phone short message (SMS) for sending Traps and Alarm message Supports Dying Gasp function RoHS Compliance | 
